sdkconfig_m5stack.defaults

#
#    Copyright (c) 2022 Project CHIP Authors
#    All rights reserved.
#
#    Licensed under the Apache License, Version 2.0 (the "License");
#    you may not use this file except in compliance with the License.
#    You may obtain a copy of the License at
#
#        http://www.apache.org/licenses/LICENSE-2.0
#
#    Unless required by applicable law or agreed to in writing, software
#    distributed under the License is distributed on an "AS IS" BASIS,
#    WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
#    See the License for the specific language governing permissions and
#    limitations under the License.
#
#    Description:
#      CI uses this to select the ESP32 M5Stack.
#
CONFIG_IDF_TARGET="esp32"
CONFIG_IDF_TARGET_ESP32=y
CONFIG_DEVICE_TYPE_M5STACK=y

# Default to 921600 baud when flashing and monitoring device
CONFIG_ESPTOOLPY_BAUD_921600B=y
CONFIG_ESPTOOLPY_BAUD=921600
CONFIG_ESPTOOLPY_COMPRESSED=y
CONFIG_ESPTOOLPY_MONITOR_BAUD_115200B=y
CONFIG_ESPTOOLPY_MONITOR_BAUD=115200

# Enable BT
CONFIG_BT_ENABLED=y
CONFIG_BT_NIMBLE_ENABLED=y

# Enable lwip ipv6 autoconfig
CONFIG_LWIP_IPV6_AUTOCONFIG=y

# Use a custom partition table
CONFIG_PARTITION_TABLE_CUSTOM=y
CONFIG_PARTITION_TABLE_FILENAME="partitions.csv"

# Vendor and product id
CONFIG_DEVICE_VENDOR_ID=0xFFF1
CONFIG_DEVICE_PRODUCT_ID=0x8001

# Main task needs a bit more stack than the default
# default is 3584, bump this up to 5k.
CONFIG_ESP_MAIN_TASK_STACK_SIZE=5120

# Enable debug shell
CONFIG_ENABLE_CHIP_SHELL=y

# Serial Flasher config
CONFIG_ESPTOOLPY_FLASHSIZE_4MB=y
CONFIG_ESPTOOLPY_FLASHSIZE="4MB"

# Disable Bluetooth modem sleep
# Enable it may cause GPIO ISR triggers continuously
CONFIG_BTDM_CTRL_MODEM_SLEEP=n
CONFIG_BTDM_CTRL_MODEM_SLEEP_MODE_ORIG=n
CONFIG_BTDM_CTRL_LPCLK_SEL_MAIN_XTAL=n

# Enable OTA Requestor
CONFIG_ENABLE_OTA_REQUESTOR=y
CONFIG_DEVICE_SOFTWARE_VERSION_NUMBER=2

# Enable HKDF in mbedtls
CONFIG_MBEDTLS_HKDF_C=y