nemgrea
diff --git a/‎printer_mods/Boingomw/Wago_mount/README.md
+20 b/‎printer_mods/Boingomw/Wago_mount/README.md
+20
@@ -0,0 +1,20 @@
+# Wago_Mounts
+Wago 221 Lever Nuts are really cool, and easy to use (and not inexpensive).  The 221-412 Lever Nut can be used to make your heater bed modular.  You can get them here: https://www.amazon.com/Lever-Nuts-Compact-Splicing-Connector-Contains/dp/B093LQSQXG
+
+There are also very nice mounting brackets for them.  The one I based mine on was created by deepfriedheroin and is available here: [V2 Bed Wagos](../../deepfriedheroin/v2_bed_wagos)
+
+But, that mod assumes nothing else is going to be taking up that space.  I am going to also use the [purge bucket and brush mod](../../edwardyeeks/Decontaminator_Purge_Bucket_%26_Nozzle_Scrubber), so I won't have enough area to take advantage of DeepFried's mount.  So I made a smaller one, that mounts flush to the same extrusion the Z-stop is on.
+
+I also added features!  
+1. It has an indexing tab on the back so it only requires one M3x8 SHCS bolt (and matching T-nut) to mount, and the indexing tab does not extend the entire length, just in case you want to push the edge past the end of the extrusion a bit for added space.
+2. It has a tiny area to wedge a flathead screwdriver in to pry the WAGO out if you need to, without having to work too hard.
+
+I printed this in PETG, but I imagine I will need to reprint in ABS once the Voron is working.  Infill doesn't really matter I don't think, but I used 70%
+
+Note:  The live pic is an older version which works, but could be better.  It's a good location example. 
+
+![Installed Old Version](./images/Installed_Older_Version.jpg "Installed Old version")
+
+![Front View](./images/5x2_front_view.png "Front View")
+
+![Back View](./images/5x2_back_view.png "Back View")