Kconfig.projbuild

#
#    Copyright (c) 2020 Project CHIP Authors
#    All rights reserved.
#
#    Licensed under the Apache License, Version 2.0 (the "License");
#    you may not use this file except in compliance with the License.
#    You may obtain a copy of the License at
#
#        http://www.apache.org/licenses/LICENSE-2.0
#
#    Unless required by applicable law or agreed to in writing, software
#    distributed under the License is distributed on an "AS IS" BASIS,
#    WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
#    See the License for the specific language governing permissions and
#    limitations under the License.
#
#    Description:
#      Configuration options CHIP ESP32 demo application.
#

menu "Demo"

    choice
      prompt "Rendezvous Mode"
      default RENDEZVOUS_MODE_BLE
      help
          Specifies the Rendezvous mode of the peripheral.

      config RENDEZVOUS_MODE_WIFI
          bool "Wi-Fi"
      config RENDEZVOUS_MODE_BLE
          bool "BLE"
      config RENDEZVOUS_MODE_THREAD
          bool "Thread"
      config RENDEZVOUS_MODE_ETHERNET
          bool "Ethernet"
    endchoice

    config RENDEZVOUS_MODE
       int
       range 0 8
       default 1 if RENDEZVOUS_MODE_WIFI
       default 2 if RENDEZVOUS_MODE_BLE
       default 4 if RENDEZVOUS_MODE_THREAD
       default 8 if RENDEZVOUS_MODE_ETHERNET

endmenu

menu "PW RPC Debug channel"
depends on ENABLE_PW_RPC
    config EXAMPLE_UART_PORT_NUM
        int "UART port number"
        range 0 2 if IDF_TARGET_ESP32
        range 0 1 if IDF_TARGET_ESP32C3
        default 0
        help
            UART communication port number for the example.
            See UART documentation for available port numbers.

    config EXAMPLE_UART_BAUD_RATE
        int "UART communication speed"
        range 1200 115200
        default 115200
        help
            UART communication speed for Modbus example.

    config EXAMPLE_UART_RXD
        int "UART RXD pin number"
        range 0 34 if IDF_TARGET_ESP32
        range 0 19 if IDF_TARGET_ESP32C3
        default 5
        help
            GPIO number for UART RX pin. See UART documentation for more information
            about available pin numbers for UART.

    config EXAMPLE_UART_TXD
        int "UART TXD pin number"
        range 0 34 if IDF_TARGET_ESP32
        range 0 19 if IDF_TARGET_ESP32C3
        default 4
        help
            GPIO number for UART TX pin. See UART documentation for more information
            about available pin numbers for UART.

endmenu

menu "Platform Diagnostics"

    config END_USER_BUFFER_SIZE
        int "Set buffer size for end user diagnostic data"
        depends on ENABLE_ESP_DIAGNOSTICS_TRACE
        default 4096
        help
            Defines the buffer size (in bytes) for storing diagnostic data related to end user activity.
            This buffer will hold logs and traces relevant to user interactions with the Matter protocol.

    config RETRIEVAL_BUFFER_SIZE
        int "Set buffer size for retrieval of diagnostics from diagnostic storage"
        depends on ENABLE_ESP_DIAGNOSTICS_TRACE
        default 4096
        help
            Defines the buffer size (in bytes) for retrieval of diagnostic data.
endmenu