fixed cursor hardcoded to refresh at 60fps #1758
Open
+16
−3
Conversation
This file contains hidden or bidirectional Unicode text that may be interpreted or compiled differently than what appears below. To review, open the file in an editor that reveals hidden Unicode characters.
Learn more about bidirectional Unicode characters
FridgeRr
changed the title
|
Nightly build for this pull request:
This comment is automatic and is meant to allow guests to get latest nightly builds for this pull request without registering. It is updated on every successful build. |
TaranDahl
added
Minor
|
If there is no need to design a switch, I think only |
|
So what's the status? was anyone able to test this? |
|
I tested it but couldn't discern any difference but I have a very slow screen anyway. |
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
Add this suggestion to a batch that can be applied as a single commit.
This suggestion is invalid because no changes were made to the code.
Suggestions cannot be applied while the pull request is closed.
Suggestions cannot be applied while viewing a subset of changes.
Only one suggestion per line can be applied in a batch.
Add this suggestion to a batch that can be applied as a single commit.
Applying suggestions on deleted lines is not supported.
You must change the existing code in this line in order to create a valid suggestion.
Outdated suggestions cannot be applied.
This suggestion has been applied or marked resolved.
Suggestions cannot be applied from pending reviews.
Suggestions cannot be applied on multi-line comments.
Suggestions cannot be applied while the pull request is queued to merge.
Suggestion cannot be applied right now. Please check back later.
Tested using latest cnc-ddraw with the renderer being direct3d9, minfps=120,maxfps=240 on a 240hz monitor, as well as cnc-ddraw onto dxvk.
singlecpu=false to be set in cnc-ddraw.ini is recommended if any initial problems are observed, as well as updating your cnc-ddraw.
Attached are the ddraw.ini settings I used. Note that refresh_rate=240 here, changing this to whatever your monitor uses may allow more compatibility. Note also that if you make a change to(mo install as example) mo/resources/cnc-ddraw.ini, make sure the change also applies to mo/ddraw.ini. For some reason I had to delete my ddraw.ini every time I made a change to my cnc-ddraw.ini.
DDRAWSETTINGS.txt
also for some reason this commit has some git submodule jank