Skip to content

Voron Trident initial release

Pre-release
Pre-release
Compare
Choose a tag to compare
@stvptrsn stvptrsn released this 16 Aug 03:06
· 52 commits to main since this release
Trident-prerelease
8904f7d
This commit was created on GitHub.com and signed with GitHub’s verified signature. The key has expired.
GPG key ID: 4AEE18F83AFDEB23
Expired
Verified
Learn about vigilant mode.

Note: This is the pre-release of Voron Trident. For the full release, which includes some minor fixes and updates, please go here!

Welcome Voron Trident, the evolution of the Voron 1 platform. While nearly every component has changed, an easy upgrade path was retained for current Voron 1.8 owners. The files attached to this release are the most up-to-date parts required to build your Voron 3D printer. Please see the list below for changes from Voron 1.8.

Release Notes:

  • Gantry
    • AB Stepper Mounts
      • Revised geometry to help prevent improper belt routing.
      • New wiring path with cover that does not capture the gantry wiring harness.
      • Optional A stepper mounted Y endstop switch.
    • XY Axis
      • Adopted the Voron 2.4 XY Axis layout with bottom mounted linear rails. This includes the ability to utilize the V2.4 style endstop pod (microswitch or hall effect)
      • Integrated the community developed MGN12 X axis setup.
      • Updated cable chain routing to match the V2.4 setup
  • Z Axis
    • Completely new three stepper configuration.
      • Utilizes MGN9H linear rails instead of linear rods.
    • Utilizes GE5C spherical bearings at each joint
    • Integrated Cable chain wire management
    • Uses the V2.4 Z endstop switch assembly
    • Retains compatibility with the V1.8 build plate
    • Increased max Z travel to 250mm
  • Skirts and Electronics Compartment:
    • Reconfigured all electronics to be located below the deck.
    • Shares dimensions and screen and side fan compatibility with Voron 2.4
    • New power supply and electronic mounts
    • New front Mini12864 display mount.
    • New recommended feet but retains compatibility with the compressor feet.
  • Panels and Exhaust:
    • Slightly modified exhaust housing utilizing two screws to better hold the filter cover.
    • Updated panel clips to support the recommended use of 3mm foam tape on the side panels and 1mm foam tape on the top and rear panels.
    • Requires new panels for all but the top panel.
  • Miscellaneous
    • Added support for 350mm build plates
    • V1.8 frame upgrade possible with minimal modifications. See frame upgrade manual.
Assets 2
Loading